Comments on: FREE ENERGY POWER GENERATOR HOMEMADE ( 100% SAVING ELECTRICITY)

By: Kywdo

Kywdo — Wed, 04 Nov 2009 09:27:32 +0000

SOON MORE !!! ( and …
SOON MORE !!! ( and a complete line electricity for a normal house ! ).

By: lumicana

lumicana — Wed, 04 Nov 2009 09:27:32 +0000

The ALTERNATOR is …
The ALTERNATOR is OK !

By: Kywdo

Kywdo — Wed, 04 Nov 2009 09:27:32 +0000

Each type of …
Each type of ALTERNATOR has its own features : POWER , TENSION , RPM , DIMENSIONS , etc. , etc. , etc.

By: Kywdo

Kywdo — Wed, 04 Nov 2009 09:27:32 +0000

It works VERY WELL …
It works VERY WELL !!!
Real POWER 100% Green Electricity !!! ( with the help of a water – wheel . or a wind – wheel , or a magnet – motor , or … etc . ) .

By: Kywdo

Kywdo — Wed, 04 Nov 2009 09:27:32 +0000

My “videos are NOT …
My “videos are NOT invitations to practice !!!
They are ONLY for theory !!!

By: Kywdo

Kywdo — Wed, 04 Nov 2009 09:27:32 +0000

JUST FOR THEORY ! …
JUST FOR THEORY ! NOT FOR PRACTICE ! : Heat is NOT good for the axis ( for its inside-metal-structure ) !

By: kingcannon69

kingcannon69 — Wed, 04 Nov 2009 09:27:32 +0000

To separate:Put it …
To separate:Put it in the freezer for a night and heat the part to be removed with blowtorch which should loosen it.Several attempts maybe required,try not to directly heat the shaft,need to keep that cooler.These are usually fitted with a several ton press so they are tight.

By: Kywdo

Kywdo — Wed, 04 Nov 2009 09:27:32 +0000

THIS IS NOT AN …
THIS IS NOT AN INVITATION TO PRACTICE ! THIS IS JUST FOR THEORY ! :
If I’ll strike too hard , or in diagonal , I’ll bend the axis !!!
So : DON’T DO IT !

By: Kywdo

Kywdo — Wed, 04 Nov 2009 09:27:32 +0000

JUST FOR THEORY ! …
JUST FOR THEORY ! THIS IS NOT AN INVITATION TO PRACTICE ! :
I hired a mecanic and told him what and how to do in some moments. 2 days with spray anti-rust and very small shocks with a hammer to allow spray to get inside, between the axis and the claw’s hole; then I put the claws ( “pins”, “heads”) on the vice’s jaws, and with a hammer I stroke a bronze drift put it on the head of the axis, several times NOT very hard (I let the NUT on the head of the axis to protect the thread).
DON’T DO IT !

By: julienhelme

julienhelme — Wed, 04 Nov 2009 09:27:32 +0000

Hi how did you …
Hi how did you seperate the claw poles of the rotor ? I have tries a bearing puller and allsorts but it;s very difficult. Thanks